This stainless steel wire rope assembly can be made the length you require. You just select the wire diameter and assembly length in metres to suit your needs (max length 30m).
The wire used in this assembly is 1x19. This was selected for its strength.
Each end is fitted with a swage stud and a hexagonal nut for locking.
This system is ideal for use where symmetry is required and where simple tensioning and locking is suitable. A dome nut can be added to the ends of the studs if desired.
For wire sizes 3mm to 26mm
This system is especially suitable for:
- Structural bracing
- Bridge suspensions
- Awning and fixture Hangers
- Staircase membranes
- Shop fitting and trellis
Your system length is measured in metres from the end of the thread as shown in the image above. Make sure to add a little extra for adjustment.
For more information on how to measure the perfect wire rope assembly or balustrade have a look at our handy infographic.
The table below provides technical data to help select the wire diameter and hole dimensions for your fixing points.
Wire sizes 12mm to 26mm are also available. For help please call 01206 390777 or contact us.
|Breaking Load KN||7.06||12.55||19.61||28.24||34.81||45.50||71.10|
All measurements in mm
The swage studs are both right hand threaded. +/- adjustment is achieved by tightening or loosening the hexagonal nuts.
The system is locked with the hexagonal nuts.
Ready to Install
Click here to ready more about our Wire Rope Assemblies