A fully machined tie rod spade, with sleek geometry, developed to meet the requirements of modern Architectural design.
System lengths up to 6 metres are available, rod connectors can be used to achieve longer spans.
For lengths over 3 metres please give us a call.
The table below gives technical data to help select the rod diameter and spade dimensions for your fixing point.
All measurements are in mm.
|Yield Load KN
|Breaking Load KN
Spade ends and conical nuts are available with
Satin ( 240 grit) finish as standard.
Highly polished finish is optional.
Tie rods and fittings are threaded left hand one end and right hand the other. +/- adjustment is achieved by rotation of the rod in a clockwise/counter clockwise direction.
Conical locking nuts have been designed to cover Tie bar threads at mid adjustment. Providing a clean line between the rod and end fitting.
Ready to Install
Tie Rod systems are supplied ready to install. Spade ends are pre-assembled and adjusted to customer's hole centre requirements.
Important note about delivery and shipping cost
Please be aware that our lead time can be up to 4 weeks.
Shipping cost may increase depending on your location and total weight of your order. You will be contacted by our sales representative if there are any changes to your shipping cost. This applies to products: F34, F33, RTP System.
You may wish to contact our sales team before your confirming your order.
Click here for more information about our Tie Rods/ Tie Bar Systems