This stainless steel wire rope assembly can be made the length you require. You just select the wire diameter and assembly length in metres to suit your needs (max length 30m).
The wire used in this assembly is 1x19. This was selected for its strength.
End 1: A fully machined swage fork
End 2: Machined fork and swage stud tensioner
This system is especially suitable for:
- Roof Tensioning
- Fabric Canopy Support and Tension Systems
- Bridge Suspension
- Awning and Fixture Hangers
System lengths up to 30 metres are available.
Your system length is measured in metres from pin centre to pin centre as shown in the image above.
For more information on how to measure the perfect wire rope assembly or balustrade have a look at our handy infographic
The table below provides technical data to help select the wire diameter and fork / clevis jaw dimensions for your fixing points.
|Breaking Load KGF
All measurements in mm
The tensioner is threaded left hand one end and right hand the other. +/- adjustment is achieved by rotation of the tensioner body in a clockwise/anti-clockwise direction.
Once adjusted the tensioner is locked in place using the hex nuts on the swage stud end.
Clevis pins are locked with split pins which are supplied as standard at both ends.
Ready to Install
Wire rope assembly systems are supplied ready to install. The tensioner is set to mid point which allows equal adjustment in and out (+/-).